Electronics
Includes switches, timers, relays, alarms, controls and electrical contacts.
Product Name: Terminal Pin
Application: Terminal for printed circuit board.
Description: This part serves as the interconnection link between a printed circuit board and wires in an electrical/electronic application.
Dimensions: .660 inch overall length by .042 inch diameter shaft.
Material: 360 Brass Alloy, 1/2 hard.
Tolerances: ± .001 inch on the diameter of the shaft with most dimensions held to ± .002 inch.
Finishes: Nickel flash with tin plating.
Fabrication: Swiss screw machine.
Special Features: Terminal pin must be readily solderable and tin plating must withstand solder temperatures to 250° centigrade without peeling or cracking.
Product Name: Self Tapping Screw
Application: Electronic circuit board.
Description: A precision miniature slotted head screw with self tapping threads.
Dimensions: .090 inch diameter head with .035 inch diameter shaft by .16 inch length.
Material: Stainless Steel
Tolerances: ± .005 inch typical with shaft dimension held to .0019 inch.
Finishes: None
Fabrication: Single spindle Swiss screw machine.
Special Features: No burrs allowed anywhere.
Product Name: Jackscrew
Application: Cable connector locking screw.
Description: A knurled and slotted fastener designed to lock cables in place on electronic equipment. The part has a knurl and slot at one end and a thread at the other end. Shown next to a two inch scale for size comparison.
Dimensions: 2.000 inch in length with a 0.157 inch maximum diameter.
Material: Carbon Steel.
Tolerances: ± 0.005 inch typical.
Finishes: Zinc Plate.
Fabrication: Single Spindle Swiss.
Special Features: No burrs allowed anywhere.
Product Name: Contact Pin
Application: Contact Pin in an electronic connector assembly.
Description: A very small and high precision male pin contact that is an important component in an electronic connector. Surface must be smooth and part must be very straight in order to mate with female part and avoid bending.
Dimensions: .320 inch overall length by .0250 inch diameter shaft.
Material: Special Beryllium Copper Alloy.
Tolerances: .0005 inch on shaft nose diameter. Many other dimensions held to ± .001 inch.
Finishes: Pre gold plated surface finish held to 32 RMS surface texture or better (part gold plated by customer).
Fabrication: Swiss screw machine.
Special Features: High precision surface that does not allow any burrs or sharp edges greater than .001 inch. Complex radius at nose of contact. SPC (Statistical Process Control) required.
